Touchscreen - PowerXL Smart Pro BL6018-0BPLA Instructions Manual

Instructions for use
Touch Screen
Manual Control
POWER When blender is first
plugged in, the blue power symbol
is all that shows. When it is touched,
the other graphics light up (except for
and ). If the blender sits without
controls touched for 30 seconds, the
screen dims.
To "wake up" the blender, touch any
of the white words or symbols.
If the power button is pressed while
the screen is dim, the rest of the
graphics will turn off.
PULSO (Pulse) Press PULSO once
and it starts flashing. While PULSO
is flashing, press it again and the
blender will pulse. PULSO always
uses the fastest speed.
Note: Use PULSO for no more than
five seconds at a time, allowing the
blender to rest briefly between each
pulse, no more than two minutes
total. This helps break up ice and
distribute the ingredients.
SPEED SLIDER WITH – AND + Use
your finger on the slider to select the
exact speed you want.
Using – makes the slider go
all the way to the lowest speed.
Using + makes the slider go all
the way to the highest speed.
START When using the speed
slider, the will flash.
Press it to start the blender.
STOP Press
to stop the blender.
25
PowerXL Smart Pro
™