32
en | Connection
Figure 6.12: Connecting a relay and the supervision contacts of a CIE to the CONTROL OUT port
Control relay
The control relay REL (changeover contact) can be used as VDE 0833-4 compliant output.
The IRIS-Net software allows the user to configure the parameters or fault types for which the
changeover contact should switch over. To integrate the device into the hazard alert systems,
a normally-closed contact (standby current principle) is recommended.
Caution!
The maximum load of the control relay is 32 V/1 A.
!
Figure 6.13: Internal configuration of the REL contact (VDE 0833-4)
2022-11 | 07 | F01U306900
CIE
4CR12
4R24
User manual
PAVIRO Controller
Bosch Security Systems