Related Manuals for Patriot PT-40-208-1
Summary of Contents for Patriot PT-40-208-1
- Page 1 Electric Fryer Installation & Operation Manual PT-40-208-1, PT-40-208-3, PT-40-240-1, PT-40-240-3...
- Page 2 Read these instructions before using and keep them available at all times! 1. General information ....................1.1 Information about the instruction manual ............1.2 Key to symbols....................2.Safety ........................2.1 General information..................... 2.2 Safety instructions for use of the device.............. 2.3 Intended use .......................
-
Page 3: Key To Symbols
1. General information 1.1 Information about the manual This manual contains information about the installation, operation and maintenance of the fryer and should be consulted as an important source of information and reference guide. Awareness of the safety instructions and instructions for use in this manual will ensure the safe and correct use of the fryer. -
Page 4: General Information
This section provides an overview of all important safety aspects. In addition every section provides precise safety advice for the prevention of dangers which are highlighted by the use of the above mentioned symbols. Furthermore, attention should be paid to all pictograms, markers and labels on the device, which must be kept in a permanent state of legibility. - Page 5 NOTICE This equipment must be installed in accordance with the appropriate national and local codes of the country and/or region in which the appliance is installed. Improper installation, adjustment, maintenance or service,and unauthorized alterations or modifications can cause property damage, injury, or death.
-
Page 6: Scope Of Delivery
Please inspect the device upon delivery. If any part is missing please contact our customer service department immediately. 4. Technical data 4.1 Technical specification Model Power Voltage Phase Wire PT-40-240-1 14kW 240V PT-40-240-3 14kW 240V PT-40-208-1 12kW 208V PT-40-208-3 12kW 208V... -
Page 7: Parts Diagram
4.2 Parts diagram... - Page 8 Unit Description Spec Part Code Rear coaming assy SS430 1.0mm Basket hanger SS430 1.5mm Top basket hanging rod Nickel coating 70201107219L Bottom basket hanging rod Nickel coating 70201107228L Frame assy Front decoration plate SS430 1.0mm Working indicator ADP-24 230V YELLOW 70101301628L Power switch SR-13...
- Page 9 Fuse holder 70101301719L Fuse 70101301728L six-terminal block 70100702864L four-terminal block 100A 70100702873L ￠PG36 Power cord bracket 70100700773 Connector S-FZS26-26 70202015882 Power cord sheath SB-16 70100701855 Electrical box cover plate Drain valve 1" 70200500746 Oil tank assy SS439 1.5mm Heater supporting plate Heater connecting plate B 245*16*2mm Heating element...
- Page 10 5. Installation and operation WARNING! Risk of electric shock! All wiring connections for this appliance must be made in accordance with the wiring diagram(s) furnished with the appliance. Refer to the wiring diagram(s) affixed to the inside of the appliance door when installing or servicing this equipment.
-
Page 11: Installation And Connection
5.2 Installation and connection The fryer MUST be installed by a qualified personal only. CAUTION! Discard the complete packing material after unpacking the device. Place the device on top of a solid, even, safe and stable surface. Do not at any time position the fryer on a flammable surface (cloth, carpet, etc.). You must not position the fryer near open fireplaces,heaters or other heat sources. - Page 12 For 1 phase appliances, Connect all wires according to the corresponding circuit diagram.
-
Page 13: Operation
5.3 Operation The operation of the fryer may only be carried out by personnel that CAUTION! have been instructed in operation of the fryer and the special hazards of frying. There is an orange heating indicator light on the front panel. The heating indicator will cycle on and off to keep the set temperature. - Page 14 To drain oil from the fry pot, grasp the drain valve handle on the drainage valve and rotate the handle. Switch the device on by means of the ON/OFF switch. The green power control illuminates. Set the temperature control clockwise to the desired temperature 120° F (49° C) and 374° F (190°C).
- Page 15 In the event you turned on the fryer without having frying oil in the fry pot or without having inserted the minimum amount of oil, the device automatically shuts down or if the 446°F temperature reaches (230 ° C) in order to protect itself from overheating. Whenever this occurs, switch off the device, shut off the main power supply and let the device cool down.
-
Page 16: Safety Instructions For Maintenance
The control panel, surface of the fryer and power cord should only be wiped off with a soft cloth and a mild cleaning agent. You must not let water enter the switching unit. This may lead to dangerous creeping current and malfunctions of the fryer. Do not use any aggressive cleaning agents or abrasive materials as these could damage the fryer. - Page 17 The above mentioned possible malfunctions are examples to give you orientation. Should these or similar troubles occur, please switch off the fryer and stop use immediately. Contact a qualified technician or the manufacturer for inspection and repair. 8. Waste disposal Discarding of fryer At the end of its service life the discarded fryer has to be disposed in accordance with the national regulations.
- Page 18 Patriot warrants its equipment against defects in materials and workmanship, subject to the following conditions: Patriot electric equipment is warranted for one (1) year, effective from the date of purchase by the original owner. A copy of the original receipt or other proof of purchase is required to obtain warranty coverage. This warranty applies to the original owner only, and is not assignable.
Need help?
Do you have a question about the PT-40-208-1 and is the answer not in the manual?
Questions and answers