Advertisement
Specification of the Headphone Amp
Frequency response:
Output Power
(each channel):
Total Harmonic Distortion + Noise
(THD+N)
Channel/channel output separation 98 dB (PO = 65 mW, f = 1 kHz)
Signal-to-Noise Ratio
Vn Noise output voltage
Output jack:
Aux Input Impedance
Recommended headphones
impedance:
Operating time:
Other technical data - power supply
LED operation/charge
status indicators:
Internal power supply:
Battery charging socket:
Charging voltage:
Charging current:
Charging time:
Battery protection:
Altenative power supply:
Mayones Guitars and Basses care constantly about the quality of their instruments and release their newer and upgraded versions, as well as search for the best possible building materials.
The company reserves the right to make changes without prior notice.
Mayones Musashi Nitōryū 2.0 Preamp - User Manual
20 Hz – 20 kHz
90 mW @ 32 Ω (THD ≤ 0.1%, f = 1 kHz)
2% (PO = 20 mW, 20 Hz – 20 kHz)
104 dB (PO = 90 mW, AV = 1)
11.7 μV(rms) (AV = 1)
1/8" (3.5 mm) TRS
10 kOhm
32 ÷ 64 Ohms (16 ohms is an allowed option)
ca.
26 hours @ 32 Ohm
(3)
on the electronics cover on the back-side
of the instrument:
1 –
Blue – Preamp / Headphone amp on
2 –
Green – battery fully charged
3 –
Yellow – battery charging
Lithium polymer battery, 3.7 V, 1400 mAh
USB type C
5 V
1 A (minimum)
ca. 3 hours (5 V, 1 A)
overcharging and deep discharging
9 V alkaline battery (preamp only)
www.mayones.com
(with preamp turned on)
- 15 -
Advertisement
