Table of Contents
Advertisement
BEFORE USING
When using a new machine or new filter for the first time, an automatic cleaning process will
occur before drinking. To ensure taste quality, it is recommended to complete the cleaning
process before using the machine.
Follow the steps:：
1. Switch on the cold water valve and the three-
way ball valve. The machine will automatically
perform water purification.
2.When the water kettle is full, pour out the water
and continue the cleaning process. It is
recommended to pour out the first four pitchers of
water and clean the kettle. After cleaning, the
machine can be used normally.
*Note: During cleaning, there may be discoloration and bubbles, which are normal phenomena due to
the discharge of food grade protective liquid and air from the filter element. After cleaning, it can be
used normally.
8
Three-way
ball valve
Cold water
valve
Kettle
MAINTENANCE
CLEANING THE PRE-FILTER
Step 1: Close the three-way ball valve and unplug the concentrate water pipe to drain the
water inside the machine.
1
Shut the three-way
2
Pull out the clip on the waste pipe
ball valve.
before pulling it out（Press on the
interface before pulling out the pipe ）
Step 2: Remove the filter for cleaning and re-install it.
1
2
Use a cross screwdriver to
Remove the Pre-filter.
loosen the screw on the filter.
nstall the filter back into the
5
Put the kettle back on
4
machine and tighten it.
its base.
3
Repeat this process several times by
taking out the water kettle and pouring
out the water until the water in the
machine is empty and the kettle is filled
to the brim.
3
Take out the filter and clean it.
6
Turn on water supply and done.
9
Advertisement
Table of Contents
