Rbioko R1 Instruction Manual page 5

INTRODUCTION
①Installation of Three-Way Ball Valve:
· Turn off the cold water valve and unscrew the
cold water hose from the valve.
· Install the three-way ball valve onto the cold
water valve and tighten with an adjustable
wrench (do not forget to use the sealing gasket
on the valve during installation).
· Install the cold water hose onto the three-way
ball valve and tighten with an adjustable wrench
(do not forget to use the sealing gasket on the
hose during installation).
②Installation of Pipe Sleeve
· Choose a suitable installation position on the
sink or countertop. The area within a radius of
3cm around the installation position must be flat.
Drill a hole with a diameter of 27mm (if there is
already a suitable installation hole on the sink,
skip this step).
· Install according to the diagram.
③Connection of Pipes
·Install the joint elbow onto the water outlet.
·Install the inlet pipe and waste pipe onto the
corresponding joint elbow.
·Secure each connection with a clip.
6
Cold water pipe
Gasket
Nut
PE pipe
Three-way
ball valve
Gasket
Cold water valve
Inlet pipe
Connector
Waste pipe
Gasket
Lock nut
Clip
Joint elbows
Inlet pipe
Waste pipe
④Installation Position Selection
· The machine can be placed directly on the
countertop or installed on the wall. If wall
installation is required, select the
installation position according to actual
needs. Installation is as shown in the diagram：
⑤Connection Diagram
Tap water
Connector
Waste water
PE pipe
Three-way ball valve
Tap water
PE pipe
Floor
Cold water valve
drain
*The pictures are for reference only, please refer to the actual product for details.
Wall
Hanging rack
Expansion bolt
Screw
Kettle
Pure water
Waste water
7