Hide thumbs Also See for Pro Attachment Series:
Table of Contents

Advertisement

26
S
TORAGE
Long Term Storage (over 30 days)
Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage mainte-
nance which includes the following:
1.
Store unit in a dry, dust free place, out of the reach of children with drive shaft housing in an upright or horizontal
position to prevent grease leakage.
Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark.
2. Place the stop switch (A) in the "OFF" position.
3. Remove accumulation of grease, oil, dirt and debris from exterior of
unit.
4. Perform all periodic lubrication and services that are required.
5. Tighten all the screws and nuts.
6. Drain the fuel tank completely and pull the recoil starter handle
several times to remove fuel from the carburetor.
7. Remove the spark plug and pour 7 cc (1/4 oz.; 1/2 tablespoon) of
fresh, clean, two-stroke engine oil into the cylinder through the
spark plug hole.
A. Place a clean cloth over the spark plug hole.
B. Pull the recoil starter handle 2-3 times to distribute the oil inside
the engine.
C. Observe the piston location through the spark plug hole. Pull
the recoil starter handle slowly until the piston reaches the top
of its travel and leave it there.
8. Install the spark plug (do not connect ignition cable).
WARNING
DANGER
A

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pro attachment pas-2601

Table of Contents