Advertisement
Quick Links
Advertisement
Related Manuals for SANKI S-CON MINI Series
Summary of Contents for SANKI S-CON MINI Series
- Page 1 S-CON MINI-PLAMO Ⓡ OPERATING AND SERVICE MANUAL...
- Page 2 Thank you very much for purchasing our S-CON MINI series. This manual is ® specialized for the belt handling of S-CON MINI-PLAMO. Before machine use, ® please carefully read this as well as S-CON MINI series operating and service ® manual.
- Page 3 BELT REMOVAL IN MAINTENANCE ― ROD REMOVAL 2. Rod removal can be easier by 1. Remove rod with hammer and supporting opposite belt edge punch as follows. with fixing tool, such as shown in picture below. 3. To remove rod, use punch on opposite 4.
- Page 4 SPROCKET ALIGNMENT ON DRIVING SHAFT When attaching sprockets on driving shaft, it is very important to align teeth of all the sprockets correctly. For this purpose, sprockets usually have alignment marks as shown in picture below. Alignment mark Align sprocket teeth. CAUTION WHEN JOINING BELT ×...
- Page 5 PIVOT ROD INSERTION Once belt length is determined, carry out belt endless processing by inserting pivot rod. 1. Insert rod. 2. Hammer rod until in fixing position. Rod head ネットの 進行方向 3. Cut off extra rod length, slightly inside belt edge. ●Function of snap rod system ●Rod end chamfering Module link...
- Page 6 BELT SLACKNESS (CATENARY SAG) Modular belt length remarkably changes depending on load and ambient temperature. Extra belt length to adapt to condition changes is managed on return side by sagging where belt is not supported. For specifications of belt slackness, refer to figures. If necessary, adjust belt length to make belt tension (or slackness) appropriate.
- Page 7 MEMO...
- Page 8 Contact us ● Particular attention is given to the manufacture and transportation of SANKI conveyors. However, if you need any information about the use or failure of the machine or any other matters, please contact our customer service. Also do not hesitate to ask us for information about conveyors in general.