Table of Contents
Advertisement
STEP 4
UTILITY BLADE INSTALLATION:
WARNING
TO PREVENT INJURIES:
Stop the motor.
Apply parking brake.
Remove the ignition key.
Attach the utility blade to the subframe as shown.
Make sure the blade is pushed in until locked into
place by the springs (item 1).
Install the plastic handgrip (item 5) on the handle
(item 1).
Insert the handle (item 1) into the support (item 2) as
shown.
Install the handle (item 1) on the control rod (item 3)
as shown and secure with a 2.5 mm hair pin (item 4).
VERIFY TIRE PRESSURE:
Check and adjust tractor tire pressure as follows:
Front tires:
Back tires:
Tire pressure must be even on both sides of the
tractor.
ADJUST SKID SHOES:
On a level surface, raise the utility blade off the
ground and insert some shims to the desired height
under the blade, lower the blade on the shims.
Loosen the bolts that hold the skid shoes and slide
them down to the ground in order to get the desired
height. Tighten the nuts firmly.
NOTE: The two skid shoes must be adjusted to the
same height.
ASSEMBLY
14-15 psi
7-8 psi
15
Attach the blade
Install handle
Advertisement
Table of Contents
