ASSEMBLY
STEP 5
ROTARY BROOM PREPARATION
Install the joint block (item 1) on the latch rod (item 2)
and secure with a retaining ring (item 3).
Install the control rod (item 4) in the joint block (item
1) and secure with a 2.5 mm hair pin (item 5).
Prepare broom
Insert the parking stands (item 1) in the stand holders
(item 2). Secure with a 5/32 x 1" cotter pin (item 3) in
the upper hole (item 4) and a hair pin 2.5 mm (item 5)
in the lower hole (item 6) of each parking stand. This
will allow the broom to rest on the stands.
Install the parking stands
19