Table of Contents
Advertisement
STEP 4
DRIVE MECHANISM INSTALLATION:
NOTE: You must remove mower deck to install
the drive mechanism.
Install the drive mechanism (item 1) by hooking the
front part of the drive frame (item 2) on the brace pin
(item 3).
Lift and attach the rear portion of the drive frame
between the supports (items 4 or 5 or 6) by inserting
a pin on each side. Select the correct holes using the
chart.
Support
104345 right side
104346 left side
104093 & 104094
Only one possibility
Secure with two 2.5 mm hair pins (item 7).
Install the belt (item 8) on the engine pulley and route
inside the belt guide (item 9).
TRACTOR WITH A MANUAL CLUTCH ACTIVATED
BY A CABLE
Readjust the belt-guides (item 2). If the belt guides
are not installed yet, refer to TRACTOR WITH A
MANUAL CLUTCH ACTIVATED BY A CABLE of
STEP 2
The belt guides (item 2) must not touch the belt (item
1) when the drive mechanism is engaged.
WARNING
TO PREVENT INJURIES:
It is the person who installs the drive mechanism
responsibility to make sure that when the clutch
is disengaged that all moving parts stop.
For more information, do not hesitate to contact
the technical support.
ASSEMBLY
Holes
Item #
Bottom
4
Top
6
5
Adjust belt guides/ Drive mechanism engaged
(View of top of drive mechanism)
17
Install drive mechanism .
Advertisement
Table of Contents
