Canon imagePASS-R1 Service Manual page 70

10. Connect the Ethernet cable between the imagePASS network port and an Ethernet port on the Windows computer.
NOTE:
• Ethernet port: Connected to the imagePASS upper part (for the user network).
• Ethernet cable: Use crossover cable
11. Switch on the Host Machine and confirm that the imagePASS becomes ON.
Wait approximately 15 seconds for the imagePASS to start up and show 00 on the LED display.
12. In the Select a Network Adapter window of the Fiery Installer Builder, select the network connection that is
corresponding to the network port that you attached the Ethernet cable to, and then click Next.
4. INSTALLING SYSTEM SOFTWARE
65