Canon imagePASS-R1 Service Manual page 10

Avoid fan blades
WARNING:
The imagePASS contains hazardous moving parts. When servicing the imagePASS, keep away from moving fan blades.
Attention:
ce produit contient des pièces mobiles dangereuses. Veuillez le maintenir à l'écart des pales de ventilateur lors de sa
maintenance.
Attenzione:
questo prodotto include parti mobili pericolose. Mantenere la distanza dalle pale della ventola quando sono in uso.
Warnung:
Dieses Produkt verfügt über gefährliche Teile, die sich bewegen. Halten Sie bei der Instandhaltung Abstand zu den
sich bewegenden Ventilatorblättern.
Advertencia:
Este producto contiene piezas móviles peligrosas. Cuando realice el mantenimiento de este producto, manténgase
alejado de aspas de ventilador en movimiento.
Waarschuwing:
dit product bevat gevaarlijke bewegende delen. Blijf uit de buurt van bewegende ventilatorbladen bij het uitvoeren van
onderhoudswerkzaamheden aan dit product.
Atenção:
Este produto contém partes móveis perigosas. Ao fazer a manutenção deste produto, manter afastado de movimento
das pás do ventilador.
Aviso:
este produto contém peças removíveis perigosas. Ao realizar a manutenção deste produto, mantenha-se longe das
lâminas removíveis do ventilador.
Electrostatic discharge
When you work with electronic components, electrostatic discharge is a concern since it can destroy circuits, or damage them,
reducing their life span. The area around the printer is most likely not static-free, and electrostatic discharge could occur.
Do the following to avoid damage due to electrostatic discharge:
• Work on a grounded antistatic mat.
• Wear an antistatic wristband, attached to the same location as the antistatic mat.
• Before you remove an electronic component from the shipping box, touch a metal area of the printer to discharge static from
your body.
• After you remove an electronic component from the shipping box, place it face up on a grounded antistatic surface.
• Leave electronic components in antistatic bags until you are ready to use them.
• Do not walk on carpet or vinyl while carrying an electronic component, unless it is in an antistatic bag.
• If you remove an electronic component from the printer, immediately place it in an antistatic bag.
Power cable
Observe the following guidelines:
• Only use the power cable that shipped with the imagePASS or an appropriate replacement power cable.
For replacement parts, see your authorized service support center.
• Before you open the imagePASS, unplug the imagePASS.
• Keep the power cable away from foot traffic.
• Do not place objects on the power cable.
• Do not plug the imagePASS into a 2-hole, ungrounded power outlet by means of a 3-prong adapter.
• Do not plug the imagePASS into a circuit connected to heating or refrigeration equipment (including a water dispenser).
• Do not plug the imagePASS into a switchable power outlet.
• Do not pull the cable to unplug the imagePASS. Instead, pull the plug.
• Do not tamper with or disable the power cable grounding plug.
• Do not use an extension cord.
5
1. Introduction