Table of Contents
Advertisement
FUNCTIONAL OVERVIEW
Front Panel
1
* The unit can also be turned on by pressing these buttons.
1. Disc tray
• Place a disc when opening the disc tray.
2. A (open/close) button*
• Press to open or close the disc tray.
3. Infrared sensor window
• Receive signals from your remote control so that you
can control the unit from a distance.
4. Display
• Refer to "Front Panel Display" on page 12.
5. C (stop) button
• Press to stop playback.
Rear Panel
1
1. AC power cord
• Connect to a standard AC outlet to supply power to
this unit.
• Unplug this cord from the AC outlet to completely
turn off the unit.
2. LAN terminal
• Use to connect a telecommunications equipment
with LAN cable.
3. HDMI OUT jack
• Use to connect to a display with an HDMI compatible
port with an HDMI cable.
4. AUDIO OUT jacks
• Use to connect a TV monitor, an AV receiver /
amplifier or other device with an RCA audio cable.
2*
6. B (play) button*
7. Q (standby-on) button
8. SD card slot
2
3
4
5
Y
P
/C
R
R
L
HDMI OUT
P
/C
B
B
LAN
COAXIAL
R
DIGITAL OUT
AUDIO
VIDEO
COMPONENT
PCM/BITSTREAM
OUT
OUT
VIDEO OUT
6
7
5. COMPONENT VIDEO OUT jacks
6. DIGITAL OUT (COAXIAL) jack
7. VIDEO OUT jack
3
4
5
• Press to start or resume playback.
• Press to turn on the unit, or to turn the unit into the
standby mode. (To completely turn off the unit, you
must unplug the AC power cord.)
• Press and hold for 10 seconds to shut down the unit.
• This button lights up in red when the unit is in
standby mode and turns off when the power is on.
• Insert an SD Memory Card and play back the
contents in it.
• Use to connect a TV monitor with component video
inputs with an RCA component video cable.
• Use to connect an AV receiver / amplifier, Dolby
Digital / DTS decoder or other device with a digital
audio coaxial input jack with a digital audio coaxial
cable.
• Use to connect a TV monitor, an AV receiver /
amplifier or other device with an RCA video cable.
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
6*
7
8
EN
9
EN
Advertisement
Table of Contents
