Tools Required; Product Disassembly Process - HP ProCurve 420 NA Product End-Of-Life Disassembly Instructions

radioactive substances

2.0 Tools Required

List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Two Philips Screw Drivers

3.0 Product Disassembly Process

3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Remove two antennas if attached to the unit (un-screw).
2. Remove the plastic cover (pull slightly out and up to remove cover)
3. Remove two screws from the bottom, use philips screw driver with tip# 0
4. Slide out the metal cover at the bottom
5. Remove 5 screws holding PCA to the chassis, use philips screw driver with tip# 1
6. Remove the PCBA from chassis
7.
8.
9.
10.
11.
12.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
EL-MF877-00
Template Revision A
Tool Size (if
applicable)
#0 & #1
Page 2