Parameter
Occupancy
Duration
Command
Config external
I/O detection
mode
Detection Delay
Time
Event mask
UnaBell LTE-M User Manual
Default Configuration
0 second
No command
Disable, no external I/O
0 second
All event triggers enabled
Description
In Occupancy Modes, this sets the period of
time from which the debounce timer starts
to countdown so if no state change is
detected past the occupancy duration (and
the timer countdown reaches 00:00) then
the device identifies the state that has
changed. For example, if this is set at 10
secs, then the device will only change state
after it detects the same state for longer
than 10 secs.
There are 4 commands available:
●
No command
●
Full-band scan
●
eSIM OTA
●
FOTA
There are 4 external I/O detection modes
available:
●
Disable, no external I/O
●
Edge
●
Pulse
●
Temperature Sensor
Delay on the detection of the triggers in
edge detection mode.
Unit: seconds
Minimum = 0 (disable detection delay)
Maximum = 7200 seconds
This defines the detection types
(rising/falling edge) and click types that can
trigger the device to send messages. The
options are:
●
Rising edge or occupied
●
Falling edge or vacant
●
Short click
●
Long click
●
Double short click
●
Extra-long click
15