VitalGo Total-Lift 425T Quick Start Manual

Total drive operation

"Total Drive"

(For detailed instructions, safety guidelines and warnings

2. Throttle

3.Forward / Reverse

eve

For Operation of the Total Drive –

1. Move the bed to Caster position – button 9 on the handset.

2. Disconnect the power cord from the wall

unplugged otherwise TOTAL DRIVE will not work)

3. Turn Console Power "ON" (1). A green light should turn on.

4. If you hear short beeps, you are in Reverse mode. In order to switch to

"forward" press button 3. Beeps will stop and you are in Forward mode.

5. Hold the headboard handles with two hands.

6. Make sure that the c a s te r s Lever is in Directional Lock (pedal up

position.

7. Press the Throttle in order to move the bed. The throttle is a adjustable. Short

push will move the bed slow, Pushing all the way will move the bed faster.

8. Moving backwards – Press Button 3 and short beeping will be heard. Now you

are in reverse mode. Push the throttle and bed will move backwards.

Total-Lift

please refer to the owner's manual)

Throttle Console

425T

™

Operation

™

Charge indicator

1. On/Off

socket.(must be

Table of Contents

Do you have a question about the Total-Lift 425T and is the answer not in the manual?

Page 1 Total-Lift 425T ™ “Total Drive” Operation ™ (For detailed instructions, safety guidelines and warnings please refer to the owner’s manual) Throttle Console Charge indicator 2. Throttle 3.Forward / Reverse 1. On/Off For Operation of the Total Drive – 1. Move the bed to Caster position – button 9 on the handset. 2.
Page 2 AFTER REACHING THE NEW LOCATION TO OPERATE THE BED 1. If you are in Reverse Mode, switch back to “Forward” by pressing button 3 on the console and stop hearing beeps. Lock the Bed casters. Turn Off power of the Total Drive by pressing button 1. Green light will turn off. If this is the stationary location of the bed, connect the power cable to the wall socket.