Philips 40PUG6300 User Manual page 14

sound of the TV picture to the Home Theater System.
Audio to video synchronization (sync)
If the sound does not match the video on screen, you
can set a delay on most Home Theater Systems with
a disc player to match the sound with the video.
For more information, press
up Audio to video sync.
Audio Out settings
Audio Out delay
With a Home Theater System (HTS) connected to the
TV, the picture on the TV and the sound from the HTS
should be synchronized.
Automatic audio to video sync
With recent Philips Home Theater Systems, the audio
to video sync is done automatically.
Audio sync delay
For some Home Theater Systems you may need to
adjust the audio sync delay to synchronize the audio
to the video. On the HTS, increase the delay value
until there is a match between picture and sound. A
delay value of 180ms may be required. Read the user
manual of the HTS. With a delay value set up on the
HTS, you need to turn off Audio Out delay on the TV.
To turn off the Audio Out delay . . .
1 - Press  and select Setup and press OK.
2 - Select TV settings > Sound > Advanced > Audio
Out delay.
3 - Select Off and press OK.
4 - Press  , repeatedly if necessary, to close the
menu.
Audio Out offset
If you cannot set a delay on the Home Theater
System, you can set the TV to sync the sound. You
can set an offset that compensates for the time
necessary for the Home Theater System to process
the sound of the TV picture. You can set the value in
steps of 5ms. Maximum setting is -60ms. The Audio

Keywords and look
Out delay setting should be turned on.
To synchronize the sound on the TV . . .
1 - Press  and select Setup and press OK.
2 - Select TV
settings > Sound > Advanced > Audio Out offset.
3 - Use the slider bar to set the sound offset and
press OK.
4 - Press  , repeatedly if necessary, to close the
menu.
Audio Out format
If you have a Home Theater System (HTS)
with multichannel sound processing capabilities like
Dolby Digital, DTS® or similar, set the Audio out
format to Multichannel. With Multichannel, the TV can
send the compressed multichannel sound signal from
a TV channel or connected player to the Home
Theater System. If you have a Home Theater System
without multichannel sound processing, select Stereo.
To set the Audio Out format . . .
1 - Press  and select Setup and press OK.
2 - Select TV
settings > Sound > Advanced > Audio Out
format.
3 - Select Multichannel or Stereo.
4 - Press  , repeatedly if necessary, to close the
menu.
Audio Out leveling
Use the Audio Out leveling setting to level the volume
(loudness) of the TV and the Home Theater System
when you switch over from one to another. Volume
differences can be caused by differences in sound
processing.
To level the difference in volume . . .
1 - Press  and select Setup and press OK.
2 - Select TV
settings > Sound > Advanced > Audio Out
leveling.
3 - If the volume difference is large, select More. If
the volume difference is small, select Less.
4 - Press  , repeatedly if necessary, to close the
menu.
Audio Out leveling affects both the Audio Out -
Optical and HDMI ARC sound signals.
14