Table of Contents
Advertisement
5.Trouble Shooting
Problem
Sanding discs (10)
do not adhere to pad
surface(1).
Insufficient vacuum to
extract debris.
Disc continues to
rotate freely after it israised
from work area.
6.Care and Cleaning
Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as they can
cause damage to the housing and malfunctioning.
· It is recommended to clean the device immediately after each use.
· Remove the battery before each cleaning.
· Keep all safety devices, air vents, and the motor housing free of dirt and dust as far as possible.
· Wipe the equipment with a clean fibre free cloth or blow it with compressed air at low pressure.
7.Technical Data
Operating voltage
Type
No-load speed
Base
Orbit
Operating/Storage conditions
Weight
Cause
Debris is reducing the effectiveness
of the hook and loop fastening.
The dust bag (9) is full or clogged.
The brake assembly may be
malfunctioning.
20 V Max
5 in 1 Multi function sander
4000-12000/min
-
1 / 3 sander
-
Delta sander
-
125mm Round sander
-
Finger sander
-
Surface sander
-
ø2.5mm (1 / 3 sander)
-
ø1.8mm (Trigonometric sander)
-
ø1.8mm (Round sander)
0 to 40°C,0-85%RH(non-condensing)
1200g (Single machine)
Suggestion
Keep discs clean. See section "11.Care and
Cleaning".
Empty the dust bag (9) and check for any
blockages.
Empty the dust bag (9) and check for any
blockages.
Turn the power off(3),remove the battery and
contact our technical support service or
other technical personnel.
10
Advertisement
Table of Contents
