YEEFERM DCMS180 Original Instructions Manual page 10

Remove any dirt or debris from the pad surface before attaching the sanding disc.
· Line the edge and holes of the sanding disc with the pad surface.
Press the disc against the pad surface, checking to make sure the full surface is securely
attached.
Remove the sanding disc by gently peeling away from edge to edge.
e) Power On/Off/Speed Control
· To start the tool, Push the switch sliding rod forward and
adjust the speed knob to reach the required grinding speed
The brake pad will engage (and quickly stop) the sanding
pad when the unit is raised from the work area.
· To turn the power off, press the power off button "O".
f) Replacement of sand base
Only when the battery pack is pulled out can the spindle be locked, Remove the sandpaper
from the base of the sand, Follow the sand change sand base as shown in the figure.
g) Installation of finger type Sander and curved surface Sander
Remove the sandpaper from the base of the sand, install finger sand and curved sand as shown in the
figure
9