Table of Contents
Advertisement
After Operation
Removing the Battery Pack
from the Machine
1.
Lift up the battery-compartment lid.
2.
Press the battery-pack latch to release the
battery pack and remove the battery pack.
3.
Close the battery-compartment lid.
Charging the Battery Pack
Important:
The battery pack is not fully charged
when you purchase it. Before using the tool for
the first time, place the battery pack in the charger
and charge it until the LED display indicates the
battery pack is fully charged. Read all safety
precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to
Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1.
Ensure that the vents on the battery and charger
are clear of any dust and debris.
Figure 20
1. Battery pack cavity
2. Battery pack venting areas 6. Handle
3. Battery pack terminals
4. Battery-charge-indicator
button
2.
Line up the cavity in the battery pack
with the tongue on the charger.
11).
g290533
5. LED indicators (current
charge)
7. Charger LED indicator
light
8. Charger venting areas
(Figure
3.
Slide the battery pack into the charger until it is
fully seated
4.
To remove the battery pack, slide the battery
backward out of the charger.
5.
Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator
Indicates
light
Off
No battery pack inserted
Green
Battery pack is charging
blinking
Green
Battery pack is charged
Red
Battery pack and/or battery charger is over or under
the appropriate temperature range
Red
Battery pack charging fault*
blinking
*Refer to
Specifications (page 11)
information.
Important:
The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Storage (page
Cleaning Under the
Machine
Service Interval: After each use
WARNING
A broken or missing washout fitting could
expose you and others to thrown objects or
blade contact. Contact with a blade or thrown
debris can cause injury or death.
• Replace a broken or missing washout
fitting immediately, before using the
machine again.
• Never put your hands or feet under the
machine or through openings in the
machine.
1.
Move the machine to a level surface.
2.
Shut off the machine and wait for all moving
parts to stop before leaving the operating
position.
3.
Lower the machine to its lowest cutting-height
setting. Refer to
20)
(page
13).
18
(Figure
20).
for more
25).
Adjusting the Cutting Height
Advertisement
Table of Contents
