Table of Contents
Advertisement
4.
Attach a hose to the washout fitting, and turn the
water on high
(Figure
Note:
Spread petroleum jelly on the washout
fitting O-ring to make the coupling slide on
easier and protect the O-ring.
Figure 21
1. Washout fitting
2. Hose
5.
Start the machine, engage the blade-control
lever, and let the machine run for 1 to 3 minutes
with the blades turning.
6.
Disengage the blade-control lever, shut off the
machine, and wait for all moving parts to stop.
7.
Shut off the water and remove the coupling from
the washout fitting.
Note:
If the machine is not clean after a single
washing, soak it and let it stand for 30 minutes.
Then repeat the process.
8.
Run the machine again and engage the blades
for 1 to 3 minutes to remove the excess water.
21).
3. O-ring
4. Coupling
g003934
19
Advertisement
Table of Contents
