Network Thermostat NetX X5-CFA Operator's Manual

This NetX X5-CFA Operator Menu Guide is a companion to the
NetX X5-CFA Installation Manual. (Part Number #240292) This document will
guide you through the hidden Operator Menu that allows you to configure
settings regular users are not allowed to access.
USING THE MENU
The Dot Matrix Display will provide feedback on the Operator Menu
configuration and selected options. The Up Button
are used to select parameters while the LEFT ARROW
RIGHT ARROW M (Accept button) are used to accept settings and navigate
through the menu. At any time you can use the CANCEL BUTTON I to
return to normal operation.
STEP 1 ACCESSING THE HIDDEN OPERATOR MENU
To access the menu, press and hold a hidden button for 5 seconds. The
hidden button is located on the bottom left of the faceplate display. (See
diagram below)
Press Here
for 5 Seconds
Pg 1 © 2020 Network Thermostat All Rights Reserved
J and Down Button K
L (Back Button) and
STEP 2 UNLOCK THE THERMOSTAT
By default, the NetX X5-CFA comes locked from the factory. you can
temporarily bypass the Lock Screen by entering the 4-digit PIN 2697 ('cows'
on a telephone keypad).
The Dot Matrix area then displays Enter PIN: 0 0 0 0, use the Up
K Buttons to select the first digit in the pin code. Press the Accept Button
(Right Arrow) to Enter the first digit. Repeat for the next three digits.
After entering the correct PIN, the settings listed below can be adjusted
using the menu. The values are stored by tapping the Accept Button, or by
allowing the display to 'time out' by not pressing any buttons for 15 seconds.
The screen will automatically re-lock when you exit the operator menu at the
end or if you press the cancel button while in the menu.
C
WARNING: If you enter the incorrect PIN, Wrong PIN will display in the
Dot Matrix display. After 3 wrong attempts, the thermostat will return to the
main screen and will not allow another attempt for 5 minutes.
<–– Turn Over for Settings ––>
NetX™ X5-CFA
Operator Menu Guide
J and Down
M
240300-01