Main Switches - Yamaha 210 FSH 2019 Operator's Manual

There are three switches on the battery
switch assembly: the "START" switch,
"HOUSE" switch, and "EMERG PARALLEL"
switch.
1
1 "HOUSE" switch (red)
2 "EMERG PARALLEL" switch (yellow)
3 "START" switch (red)
1
1 ON position (green)
2 OFF position (red)
In normal operation, keep the "START" and
"HOUSE" switches in the ON position. Keep
the "EMERG PARALLEL" switch in the OFF
position. This setting allows both batteries to
be charged automatically while the engine is
running. NOTICE: Do not turn the "HOUSE"
switch to the OFF position if the boat is
moored in the water as it will prevent the
anchor light from functioning.
Control function operation
2
3
2
If the start battery is discharged, turn the
"EMERG PARALLEL" switch to the ON posi-
tion to start the engine. Once the engine is
started or the start battery is charged, turn
the "EMERG PARALLEL" switch to the OFF
position.

Main switches

There is a main switch for each engine.
The main switch controls the ignition and
electrical circuits as follows:
OFF START
1
2
1 Main switch (port engine)
2 Main switch (starboard engine)
OFF:
Ignition circuit is switched off. The engine
cannot be started, but other switches will op-
erate. (The main switch key can be removed.)
ON:
Ignition circuit is switched on. (The main
switch key cannot be removed.)
START:
The starter motor will turn to start the engine.
(When the main switch key is released, it re-
turns automatically to "ON".)
TIP:
The engine will not start when the clip is re-

moved from the engine shut-off switch.
The starter motor will turn over without the
cord attached.
ON
BLOWER
31