Table of Contents
Advertisement
Operation
connections. Contact a Yamaha Boat
Dealer if there is a problem you cannot
locate or correct.
Attach the engine shut-off cord (lanyard)
to your PFD before operating. Failure to
attach the cord could result in a run-
away boat if the operator is ejected.
Do not apply throttle when anyone is at
the rear of the boat. Turn the engines off
or keep it at idle. Water and debris exit-
ing the jet thrust nozzle can cause se-
vere injury.
(1) Always make sure the boat is launched
and used in waters that are free from
weeds and debris, and at least 90 cm
(3 ft) deep from the bottom of the boat.
WARNING! Never operate in water
that is less than 90 cm (3 ft) deep from
the bottom of the boat. You increase
your chance of hitting an underwater
obstacle. You could be injured. Peb-
bles or sand can also be sucked into
the jet intakes, damaging the impel-
lers.
90 cm (3 ft)
NOTICE
There is a hull drain plug at the bottom of
the stern. Check the O-ring on the hull
drain plug and make sure that the plug is
tightened securely before launching the
96
boat. Otherwise, water may flood the boat
and cause it to submerge.
1
Hull drain plug
(2) Turn the battery switch to the ON posi-
tion.
(3) Push the blower switch to operate the
blowers and ventilate the engine com-
partment for at least 4 minutes.
1
1
Blower switch
(4) Attach the engine shut-off cord (lanyard)
to your PFD. Install the clip onto the en-
gine shut-off switch by pushing the clip
groove over the nut beneath the knob.
Be sure the cord is not wrapped around
the steering wheel or tangled in the con-
trols. WARNING! Check that the en-
gine
shut-off
attached correctly. If the engine shut-
off cord (lanyard) is not attached cor-
1
BLOWER
cord
(lanyard)
is
Advertisement
Table of Contents
