Fitting the Panel and Fixing the Hood Canopy
efore fixing the Hood Canopy to the Frame:
Fitting the Panel
Remove the Grease filters from the Hood Canopy;
and Fixing the Hood Canopy
Remove any Activated charcoal filters.
Working from below, fix the Hood canopy to the
Before fixing the Hood Canopy to the Frame:
• Remove the Grease filters from the Hood Canopy;
Frame provided, using the 4 screws 12f (M6 x 10)
• Remove any Activated charcoal filters.
• Working from below, fix the Hood canopy to the
provided.
Frame provided, using the 4 screws 12f (M6 x 10)
provided.
• Then hook the upper part of the Panel 3, adjusted to
size, to the rubber supports in the upper part and in
Then hook the upper part of the Panel 3, adjusted to
the lower part of the Frame.
• Slide the lower part of the Panel 3 until its metal tabs
size, to the rubber supports in the upper part and in
slot into the slots in the frame;
the lower part of the Frame.
Slide the lower part of the Panel 3 until its metal tabs
slot into the slots in the frame;
ELECTRICAL CONNECTION
• Connect the plug to the socket. The plug must be accessible.
If used fixed connection, switch must be used. Switch must be
accessible.
• Remove the grease filters (see paragraph Maintenance)
being sure that the connector of the feeding
cable is correctly inserted in the socket placed on the
side of the fan.
ELECTRICAL CONNECTION
Connect the hood to the mains through a two-pole
switch having a contact gap of at least 3 mm.
Remove the grease filters (see paragraph Mainte-
nance) being sure that the connector of the feeding
cable is correctly inserted in the socket placed on the
side of the fan.
12f
8