General Guideline And Warning; Charging Process - CipherLab RS36 Reference Manual

GENERAL GUIDELINE AND WARNING

Use specific Lithium Polymer/Li-ion charger from CipherLab only. Failure to do so may

cause fire, which may result in personal injury and property damage.
Never charge batteries unattended. When charging Lithium Polymer/Li-ion batteries,

you should always remain in constant observation to monitor the charging process and
react to potential problems that may occur.
Some Polymer/Li-ion chargers on the market may have technical deficiencies that may

cause it to charge the LiPo/Li-ion batteries incorrectly or at an improper rate. Assure the
charger you purchased works properly and always monitor charging process to ensure
batteries are being charged properly. Failure to do so may result in fire.
If at any time you witness a battery starting to balloon, swell up, smoke or hot; stop

using this battery at once and contact your dealer immediately.
If you accidentally short the battery polarity, the battery must be placed in a safe area

for observation for approximately 15 minutes. Additionally, if a short occurs and contact
is made with metal (such as rings on your hand), severe injuries may occur due to the
conductibility of electric current.
In the event of a crash due to bad shipment or other reasons, you must remove damaged

battery for observation and place the damaged batteries from other good batteries.
Never drop the batteries.

Do NOT expose battery to water.

Do NOT attempt to dis-assemble battery.

Recommended to put the battery in an enclosure to protect it from damages by liquid or

dropping from height accidentally.

CHARGING PROCESS

Please ensure to charge battery indoor such as a well-ventilated room between 20℃ to

30℃.
Do NOT charge battery under direct sunlight.

When selecting the cell count or voltage for charging purposes, select the cell count and

voltage as it appears on the battery label. As a safety precaution, please confirm the
information printed on the battery is correct.
Lithium Polymer/Li-ion batteries has limited life cycle for charging and discharging.

When life cycle has been reached, battery may swell.
The allowed charging temperature is from 0℃ to 40℃.

During discharge and handling of batteries, do not exceed 50℃.

7
Important Notices