Korg TRITON Le Manual page 5

4. CURSOR ► to "Input 1 BUS"
to "001".
5. Press [F2] ("Rec"), and in "Sample Setup", CURSOR ► to "Mode" and set to "L-Mono".
6. CURSOR ▼to "REC Setup", and highlight "Mode", and set to "Auto"
of "-30dB" CURSOR ▼to "Pre Trigger" and set to "5ms".
7. Press the [REC/WRITE] key to "arm" the sampler, and then speak into the microphone. If "ADC Overload" flashes above
the "level indicators", lower the rear panel LEVEL control until this message no longer flashes
"Recording Level" "Fader" and adjust with the DIAL while speaking into the mic. Set this for a "hot" signal level, but watch
and adjust if the display indicates, "CLIP".
8. Press [F1] ("Sample")
stop sampling, and then press [F6] ("CREATE"). Note that the "keyboard" display moves to the next key after you press
"CREATE".
9. Press the [REC/WRITE] key
sampling, and then press [F6] ("CREATE").
10. Press the [REC/WRITE] key
sampling, and then press [F6] ("CREATE").
11. Press the [REC/WRITE] key
stop sampling, and then press [F6] ("CREATE").
12. That's it! Now play the keyboard: play each note (half-step) from C2 to D#2, and you'll hear the sampled words, "Sampling
is easy with TRITON Le".
...Continue by sampling through one of TRITON Le's 89 Insert Effects:
13. Press [F3] ("In/Pref")
select "IFX" Press [F8] to "Open" this page.
14. CURSOR to "OFF" and set to "ON"
enter 5 > 2, then press the [ENTER] key ("52: Reverb Hall")
Press [F4] ("IFX ") to view and edit the effect parameters.
15. Press the [MENU] key
16. Press [F6] ("CREATE") to make a new index in the multisamples
"arm" the sampler
[START/STOP] key, speak to sample
key E2 – the next available index.
Set this value to "L/R"
Press the [START/STOP] key and say the word, "Sampling"
Press the [START/STOP] key and say, "is easy"
Press the [START/STOP] key and say, "with"
Press the [START/STOP] key and say, "TRITON Le"
CURSOR to Input 1's "BUS:" and select "IFX"
CURSOR to highlight the "00 No Effect" edit cell
Press [F1] ("Rec") Press [F8] to "Open" this page
Speak into the mic and adjust the recording level as needed (see step 7 above)
Press [START/STOP] again to stop sampling. The new sample will playback on
CURSOR to the "Create" edit cell and set the "Range" value
CURSOR ► to "Threshold" and set to a value
press [START/STOP] again to stop
Press the [MENU] key, and then press [F7] to
Speak into the microphone to hear the effect being applied
Press [F1] ("Sample").
Press [F2] ("Rec")
5
TRITON Le EasyStart
CURSOR ►to the
press [START/STOP] again to
press [START/STOP] again to stop
press [START/STOP] again to
Use the numeric keypad, to
Press the [REC/WRITE] key to
Press the