JVC GR-SXM540 Instructions Manual page 8

Grip Adjust m e nt
1) Separate the Velcro strip.
2) Pass your right hand through the loop and grasp
the grip.
3) Adjust so that your thumb and fingers can easily
operate the Recording Start/Stop Button
Power Zoom Lever
Vie w finde r Adjust m e nt
1) Set the Power Switch
2) Turn the Diopter Adjustment Control
indications in the viewfinder are clearly focused.
Shoulde r St ra p At t a c hm e nt
Thread the strap through the eyelet
back and thread it through the buckle. Repeat the
procedure to attach the other end of the strap to
y
the other eyelet
twisted. Adjust the length.
Downloaded from:
3
. Refasten the Velcro strip.
3
!
@
to " " or "
o
180° 180°
PAUSE
y
, then fold it
, making sure the strap is not
y
https://www.usersmanualguide.com/
Tripod M ount ing
Align the screw and camera direction stud on the
tripod with the tripod mounting socket
tighten the screw.
!
and
When using a tripod, be
sure to open and extend
its legs fully to stabilize
the camcorder. To
prevent damage to the
unit caused by falling
over, do not use a
small-sized tripod.
Loa ding/U nloa ding A Ca sse t t e
". 1) Open the LCD monitor fully. Slide EJECT
until the until the cassette holder opens. Do not use force
to open.
2) Insert or remove a cassette. When inserting,
make sure the label is facing outward.
appears when a cassette is loaded.
3) Press the Close button
holder until it locks into place. Close the LCD
monitor.
• Closing the LCD monitor while the cassette holder is
still open may cause damage to the LCD monitor.
• Make sure the erase protection tab is in the position
that allows recording. If not, slide the tab. Some
cassettes have removable tabs. If the tab has been
removed, cover the hole with adhesive tape.
• The cassette holder cannot be opened while the
camcorder is in the record mode or detached from
the power source.
i
8
CAUTION
i
to close the cassette
Cassette holder
t
Erase Protection tab
W
. Then
t
q
Gear
Turn to take
up slack.