Built-In Needle Threader; Drawing Up The Bobbin Thread - ELNA 5300 Instruction Manual

z
q
x
cv
z
x
w
c
q
w
w
t
r
e
q
e

Built-in Needle Threader

z Press the Up/Down Needle key q until the needle
is in an up position. Turn OFF the power switch.
Lower the presser foot.
Lower the needle threader lever w as far as it will
go. Hook e is automatically inserted into the
needle eye.
x Draw the thread from the guide r to the guide t.
The thread is caught under the hook e.
e
c Slowly release the lever while holding the thread
end and let the needle threader return to its
original position. A loop of thread is pull through the
needle eye.
v Pull the thread loop off the guide to the back and
manually bring the thread through the needle eye.
NOTE:
• The needle threader can be used with #11 to #16
size needles. Thread weight may vary from 30 to
90.
• Needle threader cannot be used with a twin needle
or wing needle.
If the needle threader does not catch a thread loop,
check the needle and positioning.

Drawing Up the Bobbin Thread

z Raise the Presser foot lever.
Turn the power switch on.
Hold the needle thread with your finger.
x Press the Up/Down needle key e twice to pick up
the bobbin thread.
Draw up the needle thread q to bring up a loop of
the bobbin thread w.
c Slide 10 cm (4˝) of both threads to the back under
the presser foot.
28