Table of Contents
Advertisement
TDM-700 Series connections
Plug-in cards:
TDM-700B
TDM-700C
8
7
2
9
10
Stand-alone units:
4
1
8
7
GENLOCK
HD-SDI
1. HD-SDI – 75 ohm BNC connector for input (camera end) or output (base end) of HD SDI video. See
page 13 for standards supported.
2. OPTICAL I/O – SFP dual fibre connector. The connector is mounted on a removable cartridge.
3. Transmission wavelength – a sticker will be fitted to the faceplate to indicate the wavelength (in nm)
of the optical transmitter, If no sticker is fitted, the wavelength can be taken as 1310 nm.
4. GENLOCK – 75 ohm BNC connector for input (base end) or output (camera end) of standard 1 V
pk-pk genlock signal. Compatible with Black Burst and Tri-level sync standards. This connection
can be used to distribute genlock to the POV locations, or to send a return video feed to the POV for
monitoring purposes.
5. ETHERNET – standard RJ45 network connector. 10/100 MB/s half-/full-duplex, with auto-negotiation.
Use this connection to interface with POV cameras equipped with Ethernet control, or if an Ethernet
link to the POV location is required for any other purpose. The connector has integral LEDs to confirm
a valid link (green) and data activity (yellow).
TDM-710B
4
1
3
5
6
5
6
9
10
DATAI/O
ETHERNET
TDM-710C
TDM-720B
12
12V DC
TDM-700 Series Operation Guide V1.2
TDM-720C
TDM-730B
11
Optical I/O
TDM-730C
7
Advertisement
Table of Contents
