Power Requirements - Bluebell TDM-700 Series Operation Manual

TDM-700C TDM-700CE
(with LEMO connector)

Power requirements

For all versions, power supply requirements are dictated by the enclosure type used.
BC-100 modular rack units:
These may be fitted with either one or two AC mains PSU modules (number specified at time of order).
Each module has sufficient capacity to power a fully-loaded rack. The AC connection is via standard
IEC cables, DC power distribution inside the rack is via the motherboard. See the User Guide supplied
with the rack units for more details.
BC-160 modular rack units:
These are fitted as standard with dual internal AC mains power supplies of sufficient capacity to power
a fully-loaded rack. The AC connection is via standard IEC cables, DC power distribution inside the rack
is via the motherboard. See the User Guide supplied with the rack units for more details.
BC101 and BC102 single- and dual-slot chassis:
These are supplied with an external Universal AC adaptor which connects to the chassis via a flying lead
terminated in a 4-pin locking XLR connector. Mains is via an IEC connector.
BC120 triple-slot chassis:
This housing for three plug-in cards is fitted with an internal AC mains supply; mains connection is via a
rear IEC connector.
TDM-7xxBE/CE Stand-alone versions:
The Stand-alone enclosures are fitted with a 4-pin XLR male connector. They are supplied with an
external Universal AC adaptor with a flying lead terminated in a mating XLR. AC mains to the adaptor is
via a standard IEC connector.
6 TDM-700 Series Operation Guide V1.2