Main Menu - Sanyo PLC-HP7000L Owner's Manual

Basic Operation
For detailed functions of each menu, see "Menu Tree" on pages 81-83.









 Input
Used to select an input source (Input 1, Input 2, Input 3 or Network) (p.32).
Note: Network will not be displayed when optional PJ-Net Organizer is not attached.
 PC adjust
Used to adjust the parameters to match with the input signal format (pp.36-38).
 Image select
For computer source, used to select an image level among Dynamic, Standard, Real, and Image 1-10
(p.39).
For Video source, used to select an image level among Dynamic, Standard, Natural, Cinema, and
Image 1-10 (p.47).
 Image adjust
For computer source, used to adjust the computer image. [Contrast/Brightness/Color management/
Color temp ./White balance (Red/Green/Blue)/Offset(Red/Green/Blue)/Auto picture control/
Advanced color/Sharpness/Gamma/Reset/Store] (pp.40-42).
For video or HDMI source, used to adjust the video image. [Contrast/Brightness/Color/Tint/Color
management/Color temp ./White balance (Red/Green/Blue)/Offset (Red/Green/Blue)/Auto picture
control/Advanced color/Sharpness/Gamma/Noise Reduction/Progressive/Reset/Store] (pp.48-50).
 Screen
For computer source, used to adjust the size of the image. [Normal/Full/Wide(16:9)/Zoom/True/
Custom/Custom adj ./Digital zoom +/-/Keystone/Ceiling/Rear/Screen aspect/Reset] (pp.43-45).
For video or HDMI source, used to adjust the size of the image. [Normal/Full/Wide(16:9)/Zoom/Natural
Wide/Custom/Custom adj ./Keystone/Ceiling/Rear/Screen aspect/Reset] (pp. 51-52).
 Setting
Used to set the projector's operating configurations (pp.53-71).
 Information
Display the input source information: Input, System, H-sync freq ., V-sync freq ., Screen, Language,
Lamp status, Lamp counter, Filter counter, Power management, Key lock, PIN code lock, Shutter
management, Simple mode, Remote control, and SERIAL NO . (p.28).
 Network
See the owner's manual of "Network Set-up and Operation".
 Guide
The key operation is displayed.
26

Main Menu

Main Menu
Sub-Menu