Table of Contents
Advertisement
Water Connections continued-
Upright Models (See Figures 1A & 1B)
The hot and cold-water connections are identified on the top of the
water heater (See figure 1A). For bottom inlet models, the cold-water
inlet is located on the side of the drain valve (see figure 1B). Connect
the hot and cold-water lines to the installed nipples using unions.
Install a listed temperature-pressure relief valve in the opening on the
side of the water heater.
Figure 1A (Top Inlet Models)
Figure 1B (Bottom Inlet Models)
9
Hide quick links:
Advertisement
Table of Contents
