Sharp XL-MP100H Service Manual page 9

1.5. How to remove the flywheel (See Fig. 5)
1. Remove the belt.
2. Remove the stop washer (E1) x 1 pc., with a small precision screw-
driver to extract the flywheel from the capstan metal.
NOTE: When the stop washer is deformed or damaged, replace it with
a new one.
1.6. How to reinstall the parts
Install each part in the reverse order of the removal with care.
1.7. How to remove the tape mechanism PWB (See Fig. 6)
1. Remove the screw (F1) x 1 pc., to remove the tape mechanism
PWB.
2. Remove the screws (F2) x 1 pc.
3. Remove the solder joints (F3) x 2 pcs., to remove the tape mecha-
nism PWB.
Mechanism
Chassis
Washerx2
Flywheel
(F1)x1
ø2x3mm
Tape
Mechanism
PWB
3 – 2
XL-MP100H
(E1)x1
Stop Washer
Driver
Stop
Washer
Figure 5
(F2)x1
ø2x8mm
Tape
Mechanism
PWB
(F3)x2
Solder
Joint
Figure 6