Changing The Remote Control Code - Sanyo VPC-HD2000ABK Instruction Manual

Changing the remote control code

The remote control unit will also work with other Sanyo cameras that can be
operated by infrared remote control. When more than one camera is present,
it is recommended to change the remote control code to ensure that only the
intended camera operates when the remote control unit is used. The remote
control code is set to "RC CODE 1" at the time of purchase.
<Changing the remote control code from "RC CODE 1" to "RC
CODE 2">
1
Aim the infrared emitter at the remote control sensor on the docking
station.
2
Simultaneously press the MENU button and the [
least 3 seconds.
3
Press a button on the remote control unit and check that the camera
is receiving correctly.
h The remote control codes are retained even if the batteries in the
remote control unit or camera are replaced.
h If the remote control codes for the remote control unit and the camera
and do not match, the remote control unit cannot be used to operate
the camera.
<Resetting the remote control code to "RC CODE 1">
1
Aim the infrared emitter at the remote control sensor on the docking
station.
2
Simultaneously press the MENU button and the [
least 3 seconds.
] button for at
] button for at
32
English