Advertisement
6.1 Fault and settlement
No.
Fault
Power on, but the
1
screen is not on
2
Instrument crash
6.2 Wireless Network Troubleshooting List
- Make sure the instrument and the router are power on and the WiFi function of the
instrument is open.
- The instrument should be within 20 meters of the wireless network access point
(wireless router)
- There is no obstacle to block the wireless signal. Remove any large metal objects be-
tween the access point and the instrument.
- The instrument should be kept away from electronic devices that may interfere with
wireless signals.
- The computer should be connected to the same wireless network with this instrument.
6.3 Precautions for Use of Lithium Batteries
- In order to extend the battery life, it is strongly recommended to connect the power
adapter when there is power supply.
- When the software gives the notice of "too low voltage" please connect the power
adapter to charge the battery as soon as possible.
- When the battery power is seriously insufficient and automatic shutdown occurs,
connect the charger immediately to charge the battery.
- If the battery causes serious over discharge during use, it will need to replace the
new battery when it cannot be recovered through charging.
- It is possible to damage the power adapter by using the power adapter to charge the
over discharged battery.
Reason
The power plug is not in
good contact
Electrical parts damage
non-normal uses
14
Settlement
Replug the power plug to ensure
firm contact
Send it to the factory for inspec-
tion and maintenance
Master reset or restarted
Advertisement
