ViewSonic PJ556D User Manual page 31

1. Turn off the projector and unplug the AC
power
2. Place a protectve sheet (cloth) beneath the
projector. Turn the projector over so you can
access the lamp cover.
3. Loosen the access panel screws and open the
panel.
4. Loosen the screws on the bottom of the lamp
assembly.
5. Grasp the lamp handle and pull the lamp
assembly drectly out of the projector.
6. Replace wth the new lamp.
7. Tghten the screws on the bottom of lamp
assembly.
8. Tghten the screws on the lamp cover.
Dispose of the used lamp according to local regulations.

Ensure that screws are tightened properly. Screws not tightened fully may

result in injury or accidents.
Since the lamp is made of glass, do not drop the unit and do not scratch the

glass.
Do not reuse the old lamp. This could cause the lamp to explode.

Be sure to turn off the projector and unplug the AC power cord before replacing

the lamp.
Do not use the projector with the lamp cover removed.

ViewSonic PJ556D
cord.
26