Resetting The Lamp Timer - ViewSonic PJD5152 User Manual

9. Tighten the screw that secures the lamp.
CAUTION
• Loose screw may cause a bad connection,
which could result in malfunction.
• Do not over tighten the screw.
10. Ensure the handle is fully laid flat and
locked in place.
11. Replace the lamp cover on the
projector.
12. Tighten the screws that secure the lamp
cover.
CAUTION
• Loose screw may cause a bad connection,
which could result in malfunction.
• Do not over tighten the screws.
13. Restart the projector.
CAUTION
Do not turn the power on with the lamp cover removed.

Resetting the lamp timer

14. After the startup logo, open the On-Screen
Display (OSD) menu. Go to the SYSTEM
SETUP: Advanced > Lamp Settings menu.
Press MODE/ENTER on the projector or Enter
on the remote control. The Lamp Settings page
is displayed. Press
timer and press MODE/ENTER on the projector
or Enter on the remote control. A warning
message is displayed asking if you want to reset
the lamp timer. Highlight Reset and press MODE/ENTER on the projector or Enter
on the remote control. The lamp time will be reset to '0'.
CAUTION
Do not reset if the lamp is not new or replaced as this could cause damage.
48 Maintenance
to highlight Reset lamp
Notice
Reset Lamp Timer?
Reset
Cancel