Universal Tool UT9914 Manual

Description

The Universal Tool model UT9914 & UT9914-2 Pistol Grip Recoilless Needle Scalers feature a patented vibration damp-
ening system. The low vibration and high blow frequency results in less operator fatigue and increased production.
These versatile tools are used on flat and irregular surfaces for removing weld flux, paint, rust, scale and to resurface
concrete.

Specifications

Number of needles (UT9914) ........................................ 19
Number of needles (UT9914-2) .................................. 38
Needle size (UT9914) ........................................
Needle size (UT9914-2) .................................. 2mm X 7"
Blows per minute ................................................... 3,400
Stroke length .............................................................
Vibration level .................................................... 3.5 m/s
Overall length ......................................................... 11
Weight ................................................................ 6
Air inlet ............................................................... ¼" NPT
Hose size ............................................................
Average air consumption ..................................... 3 CFM
Maximum operating pressure .............................. 90 PSI
PL-2080
1 / " X 7"
8
7 /
8
7
/
8
1
/ lbs.
8
3 / " I.D.
8
Universal Tool
A Division of Florida Pneumatic Manufacturing Corporation
851 Jupiter Park Lane, Jupiter, Florida 33458
Toll Free 1-800-327-9403
Pistol Grip Recoilless Needle Scalers
PLEASE READ AND FOLLOW ALL WARNINGS
Read Operating Instructions
Always become familiar with all the instruc-
tions and warnings before operating any
pneumatic tool.
Always Wear Approved Eye Protection
Impact resistant eye protection should meet
or exceed the standards as set forth in the
United States ANSI Z87.1, Occupational and
Educational Eye and Face Protection. Look
for the marking Z87.1 on your eye protection
to insure that it is an approved style. For
further information, ANSI Z87.1, Occupa-
tional and Educational Eye and Face
Protection, is available from the American
National Standards Institute, Inc., 11 West
42nd Street, New York, NY 10036.
Hearing Protection is Recommended
Hearing protection should be used when the
noise level exposure equals or exceeds an 8
hour time-weighted average sound level of
85dBA. Process noise, reflective surfaces,
other tools being operated nearby, all add to
the noise level present in your work area. If
you are unable to determine your noise level
exposure, we recommend the use of hearing
protection.
Avoid Prolonged Exposure
to Vibration
Pneumatic tools can vibrate during use.
Prolonged exposure to vibration or very
repetitive hand and arm movements, can
cause injury. Stop using any tool if discom-
fort, tingling feeling or pain occurs. You
should consult your physician before
resuming use of the tool.
90 PSIG Maximum
This tool is designed to operate at an air
pressure of 90 pounds per square
gauge pressure (90 PSIG) maximum, at the
tool. Use of higher air pressure can, and may
"
cause injury. Also, the use of higher air
2
pressure places the internal components
"
under loads and stresses they were not
designed for, causing premature tool failure.
The air supply should be clean and dry,
preferably lubricated. For best results, drain
the moisture from your compressor daily.
UT9914 & UT9914-2
i
nch
FPMC