Download Print this page

Judge JEA76 Quick Start Manual page 5

Electric carving knife

Advertisement

Cautions
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities or lack of experience or knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
This appliance is not intended to be operated by means of an external timer or a separate
remote-control system.
THE BLADES ARE VERY SHARP. TAKE GREAT CARE WHEN HANDLING AND ALWAYS HOLD
USING THE FINGER GUARDS.
Always keep the appliance out of the reach of children.
Ensure that your home electrical supply corresponds to the requirements of the appliance
- see "Specifications".
Do not connect the Mains Plug
the appliance are wet.
Unplug the appliance whenever it is not in use.
THE APPLIANCE MUST ALWAYS BE EARTHED - always connect to a mains socket with an
earth connection.
Never leave the unit unattended when it is plugged in.
The Mains Lead
the edge of the surface, where it could accidentally be snagged or pulled by children.
Do not use the Knife outdoors.
Do not place the Knife close to a heat source.
Ensure that the Mains Lead
Pull the plug (do not pull Mains Lead
Do not pull the Mains Lead
It is not recommended that the Knife be used with an extension lead.
The Knife should be used only as instructed and for the purpose for which it was intended;
there is potential for injury or damage from misuse.
Do not switch on or attempt to operate the Knife if it appears to be faulty in any way -
contact Judge Customer Services at the address given in the warranty section.
Never attempt to make any repair to the Knife yourself - contact Judge Customer Services
at the address given in the warranty section.
DO NOT IMMERSE ANY PART OF THE KNIFE BODY IN WATER.
Should the Knife accidentally fall into water, unplug immediately and do not use.
Please keep your purchase receipt.
into the socket, or use the appliance, if your hands or
should be positioned so as not to cause an obstruction or to overhang
is not near any hot surface.
to move the appliance.
Electric Carving Knife
) to disconnect from mains socket.

Advertisement

loading