Advertisement
A
B
C
HOW TO OPEN THE RP700 CABINET:
E
D
A) Remove the top cover unscrewing the 5 screws on rear panel, pull the
cover towards you and lift it up.
B) Slide the keyboard cover on rear position and unscrew two metal suppor-
ts on sides; then slide the keyboard cover full towards you and remove the
glued pastic caps on centre of two Lx & Rx black rack guides.
C) Slide again on rear direction the keyboard cover until the wheel link bar
rise the opening of removed plastic caps and lift up the keyboard cover from
cabinet.
D) Moreover, to remove the keyboard front panel, unscrew the 2+2 fi xing
screws on sides.
E) To remove the keyboard group, unscrew 16 fi xing screws from the bottom
cabinet and lift up the keyboard, after having disconnected the 2 fl at cables
F2
F1
LEAF SPRING
HOW TO INSPECT THE KEYBOARD AND TO REPLACE
THE SINGLE KEYS:
F) Remove the keyboard group from cabinet as described on point E);
then place the keyboard on fl at surface to check all mechanical & electrical
parts.
- To replace the single white & black keys, pull each key on arrow direction of
F1 fi gure; then turn up the single key from fulcrum as shown on F2 fi gure.
- To mount the single white & black keys on keyboard take care to apply the
leaf spring between the hammer corner and key back side; then place and
move each key on keyboard frame following the arrows opposite direction of
F2 fi gure.
2
Advertisement
