Advertisement
Included
A - Threaded Studs - 3
B - Allen Wrench - 1
C - Door Plaque - 1
D - Acorn Nuts - 3
E - Silicon Sealer
Tools needed
Pliers or small
Socket wrench
Figure 1
Plaque
©2023 Whitehall Products, LLC
Need additional assistance? If you have questions about your mailbox you may call Whitehall Products Customer Service: 800.728.2164
Personalized Door Plaque install for Whitehall Capitol Mailbox:
1) Follow instructions on AW-795 to drill holes through mailbox door with a 1/4" drill
bit with drilling template.
2) Apply a small amount of Silicon Sealer (E, Included with mailbox post package)
in and around the holes in the back side of the door plaque. Insert the (3)
threaded studs (A) into the back side of the door plaque. Tighten with Allen
wrench (B). (See Figure 1)
3) Position the Door plaque (C) so the studs are pushed through the holes drilled in
the mailbox door and the plaque is located within the border. (See Figure 2)
4) Apply a small amount of Silicon Sealer (E) to the inside of the mailbox around the
studs where they come through the mailbox door. Using the acorn nuts provided
(D), secure the plaques from the inside of the mailbox.
(See Figure 3) (Pliers or a small socket wrench are helpful)
A
B
E
Figure 3
Plaque
Mailbox Door
Customer Service: 800.728.2164
To attach your Personalized Door Plaques to your
Whitehall Capitol Mailbox Follow steps below.
Figure 2
D
E
www.whitehallproducts.com
C
AW-341
Advertisement
