Whitehall BALMORAL MAILBOX Installation

MONOGRAM AND SIDE ADDRESS PLAQUE INSTALLATION
FIG. 1A
C
FIG. 2A
C
©2023 Whitehall Products, LLC
Need additional assistance? If you have questions about your mailbox you may call Whitehall Products Customer Service: 800.728.2164
BALMOR AL MAILBOX
Parts Included:
B
A)
B)
C)
D)
Instructions:
C
1)
D
2)
B
3)
A
4)
B
5)
Customer Service: 800.728.2164
Balmoral Mailbox
Side Plaques - 2 (optional)
Door Monogram (optional)
2" x 2" Adhesive Tape Squares - 12
On a flat clean surface, place the Side Plaques (B)
and Monogram (C) with the personalization facing
down.
Without removing the adhesive backing, place four
(4) of the provided tape squares (D) in the corners
of each Side Plaque (B) approximately 1/4"-1/2"
from each edge. Place one (1) tape square in the
center of the monogram. Be sure to give each
square enough space to avoid overlap or overhang.
(FIG. 1A)
Once evenly spaced, peel off one (1) plastic backer
of each adhesive tape square one by one and
replace EXACTLY with the sticky side down (TAPE
BONDS IMMEDIATELY). Press firmly for 15
seconds to FULLY activate adhesive. Repeat for
each tape square.
Once the tape is set, peel off the remaining plastic
backers. Ensure correct plaque orientation before
installation. The adhesive bonds IMMEDIATELY
and cannot be repositioned. At a 45 degree
angle, rest the bottom edge of the plaque along the
inside bottom edge of the recessed side
plaque/monogram frame on the mailbox (A) for
level application. Tilt plaque forward and press
firmly for 15 seconds to FULLY activate adhesive.
Repeat for each plaque. (FIG. 2A)
Enjoy your new personalized Balmoral Mailbox!
www.whitehallproducts.com AW-1073