Advertisement
FOR PERSONALIZED MAILBOX DOOR PLAQUE INSTALLATION
ADDRESS SIDE PLAQUE TAPE INSTALLATION
©2023 Whitehall Products, LLC
Need additional assistance? If you have questions about your mailbox you may call Whitehall Products Customer Service: 800.728.2164
SEE INCLUDED INSTRUCTION SHEET AW-341
C
B
FIG. 1A
A
Customer Service: 800.728.2164
CAPITOL MAILBOX
Parts Included:
A)
Capitol Mailbox
B)
Side Plaques - 2 (optional)
C)
2" x 2" Adhesive Tape Squares - 8
Instructions:
1)
On a flat clean surface, place the Side Plaques
(B) with the personalization facing down.
2)
Without removing the adhesive backing, place four
(4) of the provided tape squares (C) in the corners
of each plaque (FIG. 1A) approx. 1/4"-1/2" from
each edge. Be sure to give each square enough
space to avoid overlap or overhang.
3)
Once evenly spaced, peel off one (1) plastic
backer of each adhesive tape square one by one
and replace EXACTLY with the sticky side down
(TAPE BONDS IMMEDIATELY). Press firmly for
15 seconds to FULLY activate adhesive. Repeat
for each tape square.
4)
Once the tape is set, peel off the remaining plastic
backers. Ensure correct plaque orientation before
installation. The adhesive bonds IMMEDIATELY
and cannot be repositioned. At a 45 degree
angle, rest the bottom edge of the plaque along the
inside bottom edge of the recessed side/door
plaque frame on the mailbox (A) for level
application. Tilt plaque forward and press firmly for
15 seconds to FULLY activate adhesive. Repeat
for next plaque.
5)
Enjoy your new personalized Capitol Mailbox!
www.whitehallproducts.com
AW-1072
Advertisement
