Table of Contents
Advertisement
EN
10
Operation
5. OPERATION
IMPORTANT!
You must fill up with engine oil and fuel before you can start the engine.
Check the fuel level and top it up if necessary
Make sure that the generator has sufficient ventilation
Make sure that the ignition cable is secured to the spark plug
Inspect the immediate vicinity of the generator
Disconnect any electrical equipment which may already be connected to the generator
5.1 STARTING THE ENGINE
Open the petrol cock (13) by turning it down
Move the ON/OFF switch (10) to position „ON" with the key.
Move the choke lever (11) to position I
Start the engine with the reversing starter (12) by pulling the handle forcefully. If the engine does not start, pull
the handle again.
Push the choke lever (11) back again after the engine has started.
IMPORTANT!
When starting with the reserve starter, the motor may recoil suddenly as it starts up, resulting in hand injuries.
Wear protective gloves when starting the equipment.
5.2 CONNECTING CONSUMERS TO THE GENERATOR
Connect the equipment you want to use to the 230 V ~ sockets (3).
IMPORTANT!
These sockets may be loaded continuously (S1) with 2100W and temporarily (S2) for a maximum of 5 minutes
with 2300 W or for a maximum of 2 minutes (with a cold motor) with 2400W.
The generator is suitable for 230 V ~ AC appliances only.
Do not connect the generator to the household mains system as this may result in damage to the generator
itself or to other electrical appliances in your home.
Note:
Some electrical appliances (power jigsaws, drills, etc.) may have a higher level of power consumption when
used in difficult conditions.
Some electrical appliances (for example televisions, computers, etc.) must not be powered by a generator.
If in doubt, consult the manufacturer of your appliance.
I.
FZI 2300-B
Advertisement
Table of Contents
