Craftsman CMXGWAS020735 Operator's Manual page 8

Operation
Check / Connect Gun and Hose
1 . If spray gun trigger depresses without pressing trigger
lock or if spray gun remains depressed when released,
replace spray gun immediately .
Trigger Lock
2 . If high pressure hose is damaged, exposing inner
mesh, replace immediately .
3 . Attach high pressure hose to spray gun and high
pressure outlet on pump . Tighten by hand .
WARNING! The high pressure fluid could cut
through skin and its underlying tissues, resulting
in serious injury and possible amputation . Never
attach spray wand directly to high pressure hose .
8
Check Water Inlet Screen / Connect Garden Hose
1 . Inspect inlet screen . Remove debris or replace if
damaged .
2 . Run water through garden hose (not to exceed 50
ft (15 m) to clean out debris, then connect to water
inlet .
NOTICE There must be at least 10 ft (3 m) of unrestricted
garden hose between the pressure washer inlet and any
device, such as a vacuum breaker, to prevent pump
damage .
3 . Turn on water, point spray gun in safe direction, press
trigger lock and depress trigger to purge pump system
of air .
4 . Attach spray wand to spray gun . Tighten by hand .
Inlet Screen
Craftsman.com