Craftsman CMXGWAS020735 Operator's Manual page 7

Operation Location to Reduce the Risk of Fire
WARNING! Exhaust heat/gases could ignite
combustibles, structures or damage fuel tank
causing a fire, resulting in death or serious injury .
• Pressure washer must be at least 5 ft (1 .5 m) from any
structure, overhang, trees, windows, doors, and any wall
opening, shrubs, or vegetation over 12 in . (30 .5 cm) in
height .
5 ft (1 .5 m) min .
5 ft (1 .5 m)
min .
• Do not place pressure washer under a deck or other type
of structure that may confine airflow . Smoke alarm(s)
must be installed and maintained indoors according to the
manufacturer's instructions /recommendations .
• Carbon monoxide alarms cannot detect smoke .
• It is a violation of California Public Resource Code Section
4442, to use or operate the engine on any forest-covered,
brush-covered, or grass-covered land unless the exhaust
system is equipped with a spark arrester, as defined in
Section 4442, maintained in effective working order .
Other states or federal jurisdictions may have similar laws,
reference Federal Regulation 36 CFR Part 261 .52 .
• Contact the original equipment manufacturer, retailer, or
dealer to obtain a spark arrester designed for the exhaust
system installed on this engine .
• Replacement parts must be the same and installed in the
same position as the original parts .
Step 2: Oil and Fuel
Check Oil Level
1 . Make sure pressure washer is on a level surface .
2 . Refer to engine operator's manual and follow oil and
fuel recommendations and instructions .
Transporting
Do not tip engine or equipment at an angle which causes
fuel to spill .
Step 3: Set Up
Clean Debris
Clean any accumulated debris . Keep area around muffler
free from any debris .
• Use a soft bristle brush to loosen caked on dirt or oil .
• Use a damp cloth to wipe exterior surfaces clean .
Lubricate O-rings
Lubricate all connections shown to extend the life of the
o-rings .
1 . Inspect and clean connecting surfaces prior to
lubrication and assembly . Replace o-rings that are
damaged or missing . See Common Service Parts.
NOTICE Never repair leaking connections with sealant of any
kind . Replace o-ring .
2 . Use a small brush or cotton swab to apply a light
coating of grease directly to o-rings .
Spray Wand
Operation
Spray Gun
High
Pressure
Hose
7