Advertisement
QUICK START GUIDE
CAUTION: Verify battery voltage and polarity with a voltmeter before proceeding.
Note: RETURN must be externally connected to DC Reference (CO) ground.
Note: External DC protectors must be installed in the non-grounded (non-RETURN) side of the DC path.
Shelf to Shelf Distribution
signals cables
SW1 Output
Voltage Switch
SW2 Shelf ID Switches
Shelf to Shelf cable
Step 5 - Set Controller Jumpers - Primary Shelf Only
Set LAN Port and Relay per Galaxy Pulsar Edge Controller Quick Start Guide
Step 6 - Install Controller - Primary Shelf Only
Install Controller in shelf controller slot per Galaxy Pulsar Edge Controller Quick Start Guide
Step 7 - Set Shelf Switches
Shelf Switches are on rear - figure above.
SW1 - Set Rectifier output voltage for shelf: 48V or 24V.
SW2 - Set Shelf Number: 1 for 1st shelf, 2 for 2nd shelf, etc.
Note: ID conflict alarm will occur if two shelves are set to same number.
Step 8 - Install Signal and Communications Cables
Connectors are on rear - figure above.
1. J1
Alarms - office alarms and signals. See Information: Alarm Connections.
2. J3-4 Shelf-to-Shelf communication - Connect adjacent shelves. Connect 1-Wire Battery Temp and Voltage Monitor
(optional).
3. J5
LAN - Connect to Ethernet network.
4. J7
Distribution Panel signals - Connect to Distribution Panel if present.
Step 9 - Install 1-Wire Battery Temp and Voltage Monitor per Galaxy Pulsar Edge
Controller Quick Start Guide -
1. Connect 1-Wire Battery Temp and Voltage Monitor to upper J3/J4 connector on Rectifier Shelf with controller.
Page 3
© 2021 ABB. All rights reserved.
Distribution Shelves if present
1-Wire Battery Temp Monitor
Primary Rectifier Shelf with
controller
Expansion Rectifier Shelf
without controller
if present
J5 LAN Port
J1 Alarm Inputs and Outputs
Signal Connection and Shelf ID Switches
Optional
USB Craft Port
Advertisement
