Table of Contents
Advertisement
Quick Links
Your JM-3080 Jet-Set gas-powered
water jet is designed to give you years of
trouble-free, profitable service. However,
no machine is better than its operator.
Read, understand and follow all
safety warnings and instructions provided
with the product. Failure to follow the
warnings and instructions may result in
electric shock and/or serious injury. Save
all warnings and instructions for future ref-
erence.
SAVE THESE INSTRUCTIONS!
JM-3080
Operating Instructions
™
Gas Jet
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for General Pipe Cleaners JM-3080
Summary of Contents for General Pipe Cleaners JM-3080
- Page 1 ™ JM-3080 Gas Jet Operating Instructions Your JM-3080 Jet-Set gas-powered water jet is designed to give you years of trouble-free, profitable service. However, no machine is better than its operator. Read, understand and follow all safety warnings and instructions provided with the product.
-
Page 2: Safety Symbols
JM-3080. Do not direct discharge stream at peo- SAFETY SYMBOLS ple. This equipment can produce a high... -
Page 3: General Safety Rules
Jet-Set JM-3080™ GENERAL SAFETY RULES JET SAFETY 1. Do not operate jet above rated pressure or above 140 degrees (rated water temperature). Operating jet above rate specifica- WARNING tions risks damage to the pump and related components, and will Read and understand all instructions. Failure to follow all in- void the warranty. -
Page 4: Buffer Tank
Jet-Set JM-3080™ BUFFER TANK 2. Make sure the nozzle you are using matches the pump size. A 3000 psi pump requires a different nozzle orifice than a 1500 psi The J-3080 is equipped with a 12 gallon buffer tank. If the incoming pump. -
Page 5: Operation
Jet-Set JM-3080™ NOZZLE SELECTION GUIDE Connect one end of a water supply hose (not included) to the water supply and the other end to the water inlet of the jet ma- chine. Water supply must be a minimum of 20 psi and not to HOSE SIZE 1/4”... -
Page 6: Special Applications
Jet-Set JM-3080™ OPERATION CONTINUED SPECIAL APPLICATIONS 8. Guide the jet hose into the drain line. Do not feed the hose contin- ICE BLOCKAGES uously, but rather, move the hose forward and back to allow the High pressure water can be used to clear an ice blockage. A 3000 psi pressure to break up the stoppage and the water flow to flush it gas jet can clear a 4”... -
Page 7: Maintenance
Jet-Set JM-3080™ The Spray Wand can be used to clean your truck or other applica- ACCESSORIES tions. Caution: Never clean the machine with its own spray. Follow HANDY-REEL WITH FOOT PEDAL the same procedures listed previously for safety, set-up, operation, - Cat # HM-200-W (OPTIONAL) and maintenance. -
Page 8: Troubleshooting Guide
Jet-Set JM-3080™ TROUBLE SHOOTING GUIDE Problem Probable Cause Solution Low pressure. Worn, clogged, or oversized nozzle. Clean or replace worn nozzle. Check nozzle size. Clogged water inlet strainer. Clean or replace strainers. Inadequate water supply. Make certain water supply valve is on fully. Make certain water supply hose is at least 3/4”... - Page 9 Jet-Set JM-3080™ TROUBLE SHOOTING GUIDE continued Problem Probable Cause Solution Washer fails to draw detergent. Detergent metering valve closed, or Open detergent metering valve, following procedure in operating valve clogged or defective. instructions. Back pressure in hose (when using Contact dealer for proper injector size when adding lengths of additional lengths of pressure hose).
- Page 10 JM23-0023 ENGINE - MITM (0AM) JM1-0264 INLET FILTER JM19-0238 JM43-0078 NIPPLE JM23-0362 ELBOW JM23-0081 10 DECAL - JM-3080 SIDE PANEL COMPONENT TOOL BOX JM20-1213A64 (SEE JM71-0004) LOCKWASHER (0AH) JM29-0006 11 BALL KNOB JM7-0223 DECAL - SILVER STICKER 12 SPRING JM49-0165...
- Page 11 Jet-Set JM-3080™...
- Page 12 Jet-Set JM-3080™ JM-3080 PUMP/GEARBOX PARTS LIST ITEM DESCRIPTION PART # GEARBOX JM47-0031 PUMP JM3-0300 VALVE CAP JM46-1430 DATE SERIAL # BREAK REASON FOR CHANGE 08/05/2015 28003283 Unloader change, Ball Valve Change 01/29/2019 28006259 Changed Hose Reel...
- Page 13 Jet-Set JM-3080™ JM-3080 PUMP ASSEMBLY PARTS LIST (Drawing on next page) ITEM DESCRIPTION PART # ITEM DESCRIPTION PART # HEAD BOLT JM27-8470 29 SIDE COVER W/ SIGHT GLASS JM46-0918 WASHER JM29-0155 30 SHIM JM46-0947 O-RING JM25-0647 SHIM JM46-0948 COMPLETE VALVE (SEE KIT 70-0584)
- Page 14 Jet-Set JM-3080™...
- Page 15 Jet-Set JM-3080™ JM-3080 HOSE REEL PARTS LIST ITEM DESCRIPTION PART # LOCKNUT JM30-0157 WASHER JM28-0003 3/8" SWIVEL JM24-0362 HOSE JM15-0311 ELBOW JM24-0105 SCREW COUPLER JM23-0490 BOLT JM27-0016 ISOLATOR JM14-0069 WASHER JM28-0002 LOCKNUT JM30-0155 HOSE REEL STAND JM20-1221A01 BOLT JM27-0066 HOSE REEL...
- Page 16 Jet-Set JM-3080™ JM-3080 WATER TANK ASSEMBLY PARTS LIST ITEM DESCRIPTION PART # ITEM DESCRIPTION PART # HOSE BARB JM23-0360 17 BALL VALVE JM22-0278 HOSE *(ONE FOOT REQUIRED) JM15-0007 18 NIPPLE JM23-0003 HOSE CLAMP JM42-0011 19 NIPPLE JM23-0082 ELBOW JM23-0119 20 STRAINER...
Need help?
Do you have a question about the JM-3080 and is the answer not in the manual?
Questions and answers